5
UHF CB Transceiver
Getting Started
Attach / Remove the Belt Clip
To attach the belt clip:
1. Align the belt clip over the 2 screw holes on the back of the battery pack.
2. Use a suitable Philips screwdriver to fasten the 2 belt clip screws to the
battery pack.
To remove the belt clip:
1. Use a suitable Phillips screwdriver to loosen the 2 belt clip screws to
release the belt clip from the battery pack.
NOTE
Always ensure the radio is powered off before removing the
battery.
Install / Remove the Battery Pack
To remove the battery pack
1. Make sure the radio is powered off.
2. Push down on the release lever at the top of the battery and lever the
battery away from the radio.
To install the battery pack
1. Lever the bottom of the battery into the bottom of the battery compartment
and then fit the battery in until the release latch at the top locks into place.
