WARNING
Installation
1. Install the memory card.
Remove the card slot cover, and insert the memory card into the card slot on
the side of the doorbell.
Motion detection does not support
recording without the memory card.
The memory card should
avoid direct rain or moisture.
2. Attach the mounting template.
• Align the cable hole on the mounting template with
the cable hole on the wall.
• Attach the mounting template on the wall.
3. Connect the power cables.
Make sure you have powered off the main power switch of your home. Connect a resistor
(included in the box content) to the doorbell if no electrical chime or mechanical chime is
connected.
• Loosen the screws on the rear panel of the doorbell, put loops of power
cables (included in the box content) into the screws, and then tighten them.
• Pull the power cables from the wall, and connect to the power connector.
• Connect the power cables to the power connector (included in the box content).
4. Install the doorbell.
1
- Drill 2 holes on the wall according to the mounting template.
- Insert the anchors into the drilled holes.
Do not scratch the lens’ glass when installing the doorbell.
2
- Route the cables and insert cables and power
connector into the wall.
- Align the screw holes on the doorbell body with
the drilled holes on the wall.
- Fix the doorbell body to the wall tightly with
2 screws.
3
- Connect the U-Bell to the Uniden One application.
Do not put the faceplate on until after fully
connecting to the app.
4
- Put the faceplate to cover the doorbell body.
- Use 1 set of screws to fix the faceplate with the
doorbell body tightly.
Memory Card
118 mm
42 mm
Mounting Template
Paste the template on the
required place.Drill screw
holes and cable holes
according to the template.
Hole A:Cable Hole.
Hole 1:Wall Mounting Screw
Hole.
.
.
Power Cable
Power
Connector
Anchors
Screws
Set Screw
NOTE
NOTE
NOTE
COPYRIGHT ©2017 Uniden America Corporation. ALL RIGHTS RESERVED.
5
