(16 VAC to 24 VAC)
Resistor
WiFi Video Doorbell
Symbol Conventions
The symbols that may be found in this document are defined as follows:
Provides additional information to emphasize or
supplement important points of the main text.
Indicates a potentially hazardous situation, which if not
avoided, could result in equipment damage, data loss,
performance degradation, or unexpected results.
• The working temperature of the device is from -30° C to 50° C .
• All electronic operation should be strictly in compliance with the electrical
safety regulations, fire prevention regulations and other related regulations in
your local region.
• Do not connect several devices to one power adapter as adapter overload may
cause over-heating or fire hazard.
• Please make sure that the power has been disconnected before you wire or
install the device.
• When the product is installed on a wall, the device shall be firmly fixed.
• If smoke, odors or noise rise from the device, turn off the power at once and
unplug the powercable, and then please contact the service center.
• If the product does not work properly, contact the retailer you purchased it
from or Uniden customer support. Never attempt to disassemble the device
yourself. (We shall not assume any responsibility for problems caused by
unauthorized repair or maintenance.)
• Do not drop the device or subject it to physical shock, and do not expose it to
high electromagnetic radiation. Avoid the equipment installation on vibrations
surface or places subject to shock.
• Do not place the device in extreme heat (refer to the specification of the
device for the detailed operating temperature), cold, dusty or damp locations,
and do not expose it to high electromagnetic radiation.
• The device cover should be kept away from rain and moisture.
• Exposing the equipment to direct sun light, low ventilation or heat source such
as heater or radiator should be avoided or damage may occur.
• Do not aim the device at the sun or extra bright places. A blooming or smear
may occur otherwise, and affecting the endurance of sensor at the same time.
• Avoid direct contact with the device cover, because the acidic sweat of the
fingers may erode the surface coating of the device cover.
• Please use a soft and dry cloth to clean inside and outside surfaces of the
device cover, do not use alkaline detergents.
• Please keep all packaging after unpacking them for future use. In case any
failure occurs, you will need to return the device to the retailer with the original
packaging. Transportation without the original packaging may result in
damage to the device and lead to void of warranty.
• Please connect a resistor (included in the box content) to the doorbell if no
electrical chime or mechanical chime is connected.
Make sure the power voltage across the doorbell
is between 16 VAC and 24 VAC.
NOTE
WARNING
WARNING
NOTE
3
