Troubleshooting
If your EXP 9200 Cordless Telephone is not performing to your expectations,
please try these simple steps. If you are still unable to resolve the problems,
contact Uniden Customer Service at: (800) 297-1023, 8 AM to 5 PM Central,
Monday through Friday. Note:
Do not attempt to service this unit yourself.
All service must be done by qualified service personnel.
Problem
Suggestion
Charge light won’t come on when
Handset is placed in Base Unit.
Make sure the AC Adapter is plugged into
the Base Unit and wall outlet.
Make sure Handset is properly seated in
Base Unit.
Make sure the Nickel-Cadmium Battery
Pack is properly placed inside the
Handset.
Make sure that the charging contacts on
the Handset and Base Unit are clean.
Audio sounds weak and/or scratchy.
Make sure that the Base Unit antenna is
fully vertical.
Move the Handset and/or Base Unit to
different locations and try again.
Can’t make or receive calls.
Check both ends of the Base Unit
telephone line cord.
Make sure the AC Adapter is plugged into
the Base Unit and wall outlet.
Disconnect the AC Adapter for a few
minutes, and then reconnect it.
Handset doesn’t ring or receive a page.
Nickel-Cadmium Battery Pack may be
weak. Charge the battery on the Base
Unit for more than 12 hours.
Set the RING ON/BATT SAVE switch on the
Handset to “RING ON”.
Make sure the Base Unit antenna is fully
vertical.
The Handset may be too far away from
the Base Unit.
Place the Base Unit away from noise
sources.
The Digital Security Code may be erased.
Set the Digital Code. (See page 5 for
instructions.)
Base Unit doesn’t ring or receive a page.
Set the Base Unit RINGER/VOLUME switch
to “LO” or “HI”.
23
