Uniden DSS7855, Owner'S Manual

Page: 68 / 84

Changing the Digital Security Code
Find Handset
Installing the Beltclip
The digital security code is an identification code used to connect the handset and the base
unit. Normally, setting the code is not necessary. In the rare situation that you suspect
another cordless telephone is using the same security code, you can change the code. To
change the digital security code:
1) De-register all the handsets you have (see “De-register the handset“ on page 28).
2) Register the handsets by following step 2-3 in “Register the handset“ on page 63.
To locate the handset, press on the base when the phone is in standby mode.
All registered handsets beep for 60 seconds, and Paging appears on the handset display. To
cancel paging, press any key on the handset or on the base.
Insert the beltclip into the holes on each side of the handset.
Press down until it clicks.
Pull either side of the beltclip to release the tabs from the holes.
flash/find hs
flash/find hs
To attach the beltclip
To remove the beltclip
Headset Installation
Your phone can be used with an optional headset. To use this
feature, insert the headset plug
into the headset pack. Your phone is ready for hands-free
conversations. (Headset can be purchased by visiting our website;
www.uniden.com.au , www.uniden.co.nz ).
!
If the battery pack
is completely
drained, the
handset will not
beep when
paging.
[67]