Automatic Operation
The UNIBIZRO Water Purifier is a product of advanced technology, which ensure ssa fe and clean
drinking water. The purifier is easy and convenient to install.
Installation Instructions
Installation Procedure :
The purifier automatically shuts off when the
storage tank becomes full.
The purifier does not start when inlet water
2
supply pressure is below 0.3 kg / cm
The purifier automatically restarts when water
level drops below the maximum.
The purifier does not allow any water rejection
in absence of electricity / when tank is full.
Recommended Site Preparations :
220 V single phase AC connection not more than 3m away from the point of installation of purifier.
Raw water supply with ½" nipple not more than 3m away.
Drain for rejected water not more than 3m away.
Space as per dimensions of the purifier.
Wall/plane surface for mounting two screws and holding the machine.
The system and installation must comply with state and local laws and regulations.
UNIBIZRO Water Purifier is a wall mountable purifier. Make sure it is mounted on a wall.
Avoid installation on wooden and metallic stands.
For optimum performance and minimum inlet pressure required, ensure that the raw water
supply tank is at least 10 ft above the level at which the purifier is installed.
It is preferable to install the purifier near a sink so that inlet and reject water lines easily available.
Specific Instructions :
Fix the SS ball valve to the
shown in the figure.
¼ inch port of the 3-way connector as
Slot holes
Carefully hang the purifier on the wall with the help of wall mounting slot
holes present on the back side of the purifier as shown in the figure below
2.
3.
Connect the 3-way connector to the raw water supply as shown in
the figure. The threaded end of the 3-way connector is fitted in line
with the raw water supply. The other end can be connected to a tap
or can be plugged off if not required.
4.
Now connect one end of the white pipe to the SS ball value and other
end to lower pushfit elbow fitting on the left hand side of the purifier
labeled as WATER IN. (Note: White pipe is for raw water supply)
5.
Screw in the two 16x25 self taping screws (supplied with the package) on a same horizontal
level at a distance of 5.4 inches (138mm) from each other in the wall.
1.
Similarly, connect one end of the blue pipe to the upper elbow fitting
connector labeled as REJECT WATER and leave the other end in the
drain.(Note: Blue pipe is for reject water)
6.
Before connecting the power supply, it is important that you perform
the following functions:
(a) Open the SS ball value (Handle parallel to the ball valve) to start the
flow of water into the purifier.
(b) Wait for 2-3 minutes to ensure that the filters are soaked in water.z
7.
A unique feature in UNIBIZRO Water purifier is the TDS control valve, which is not available
in any other domestic water Purifier till date. This feature allows the user to Control the cntent
of natural minerals (TDS) in Purified water.
To increase the level the TDS user can turn the screw of the value anticlockwise; it will result in
more mineral content in treated water. To reduce the TDS level, user can turn the screw value
clockwise, it will result in less mineral content in treated water. We recommend the TDS of the
purifier to be kept at lowest but not below 50 mg/l.
TDS Adjustment*
7
8