Switch on the power supply.
Wait till the storage tank fully fills up.**
Switch off the power supply.
Drain the storage tank by opening the drain
plug present at the bottom of the storage tank
Starting Up the Purifier
Although the rejected water has high concentration of salts. this rejected water usually goes down
the drain but if required, can be used for gardening purposes. It has high concentration of salts and
minerals which accelerate plant growth. Rejected water can also be used for cleaning purposes ,i.e.
Utensils Cleaning, Mopping, etc.
Recommended Uses of Reject Water
Maintenance
To ensure that the purifier operates at its
optimum level, a routine maintenance
must be performed. The frequency of the
maintenance will greatly depend upon the
raw water quality and consumption of
treated water.
Storage tank must be drained once in 2
weeks. To do so, switch off the power
supply, open the drain plug at the bottom
of the tank & allow the water to drain.
Then screw back the plug and switch on
the power supply.
Replace sediment, activated carbon & post
carbon.
After every 12 months. It is recommended to
change the FRT when the filters are
replaced.
Replace the RO membrane once in 2 years.
Replace the UV Lamp once in 2 Years.
If you are not going to use the purifier for a
long time ( in case you are on a holiday, tour
or out of home), make sure that you
disconnect the power supply, turn off the
raw water supply and drain the storage tank.
The reverse osmosis system contains a replaceable treatment component critical for the
effective reduction of total dissolved solids and that product water shall be tested periodically
to verify that the system is performing properly.
Note: Filters and membrane are consumables. Their replacement time is dependent on the quality
of raw water and water consumption. They are not covered under the warranty. However, if a
filter chokes within six months and a membrane within a year, it will be cleaned/repaired/replaced
free of cost. Changing the filters and system inspection is available on call. The treatment capacity
of RO membrane will reduce with time due to clogging of pores of membranes.
“This reverse osmosis system contains a replaceable component critical to the efficiency of
Replacement of the reverse osmosis component should be with one of identical specifications as
defined by the manufacturer, to ensure the same efficiency and contaminant reduction
Performance."
Technical Specifications
so as to remove any dust particles present in
the pipes and storage tank.
Close drain plug & switch on the power
supply.
The purifier is ready to use.
Replacement of spare parts is
as follows
SP Inline Sediment Filter 10"
SP Inline Carbon Block Filter 10"
SP RO Membrane 10" Housing
SP Post Carbon Filter (White )
PRODUCT
UNIBIZRO Water Purifier
Product Code
Applications
Purification Capacity
Body Material
Mounting
Dimensions(mm)
Inlet Water Pressure/Temp (Min)
Inlet Water Pressure/temp (Max)
Filter Cartridge
UV Lamp Wattage
Weight
Storage Capacity
Purification Production Rate
Maximum Duty Cycle
Membrane Type
Booster Pump Voltage
Input Power Supply
-
Suitable for Purification of Brackish / Tap Water
Upto 15 LPH*
ABS
On the Wall
L 410 W 260 H 5200
3Kg / cm2 or 4.267psi / 10°C
3 Kg / cm or 42.67psi / 35°C
Sediment, Carbon Block Filter and Post Carbon
11 W
9.400 kg.
9 L
15 L/hr.
75 L/day
Thin Film Composite RO
24 V DC
100-300 V ~, 50 Hz, 800 mA
9
10
