4.3 Output Arbitrary Wave
UTG9000C-II stores 20 types of arbitrary waveforms. See Table 4-4 (list of
built-in arbitrary waves) for the name of each waveform.
4.3.1 Enable Arbitrary Wave Function
Press the key to enable the arbitrary wave function, the instrument will
output the arbitrary waveform with the current settings.
Select the built-in arbitrary waveform by pressing or .
4.3.2 Select Arbitrary Wave
Picture 4-23 Arbitrary wave output
Table 4-4 List of built-in arbitrary waves
Arb0
Arb1
Arb2
Arb3
Arb4
Arb5
Arb6
Arb7
Arb8
Arb9
Up_tri
log
AbsSine
AmpALT
AttALT
EEG_A
Cardiac
GaussianMonopulse
GaussPulse
LogNormal
Arb10
Arb11
Arb12
Arb13
Arb14
Arb15
Arb16
Arb17
Arb18
Arb19
Lorentz
Sinc
SineVer
StairUD
Trapezia
Pulseilogram
VOICE
StepResp
TV
Radar
4.4 Power Amplifier Output
The built-in power amplifier has a full power bandwidth of up to 200kHz, a
maximum output power of 4W, and an output slew rate greater than 18V/μs.
Long press Output (about 3s), Output LED breathing indicates that the
power amplifier has an output, and the output interface is located at the rear
panel BNC (UTG9002C-II does not have this function and interface).
Chapter 5 Fault Handling
Possible faults in use of device and troubleshooting methods are listed below,
please handle them according to corresponding steps. If they cannot be
handled, please contact with the dealer or local office, and provide the machine
information (method: long press System for 3 seconds).
5.1 No Display on Screen (Blank Screen)
Press the power switch, if the signal generator still shows the blank screen:
1) Inspect whether power source is connected well.
2) Please restart the instrument.
5.2 No Waveform Output
Setting is correct but no waveform is outputted:
1) Inspect whether BNC cable and channel output terminal are connected
correctly.
2) Check whether the Output button is turn on.
UTG9000C-II User Manual