Uni-Trend Technology (Chengdu) Ltd.
Page 23 of 27
Communication & Control Software for UTD2025_3025 Series Oscilloscopes User Manual
3.2
Ethernet (LAN) interface controls
The Ethernet port is a dedicated interface module of UTD2025_3025 Digital Storage Oscilloscopes. This TCP/IP
protocol embedded module can provide direct Ethernet connection to a UTD2025_3025 series oscilloscope. After
installing the communication and control software, you can operate your oscilloscope on remote control through
LAN or the Internet. As it supports concurrent visit by multiple users, there are no geographical and users
restraints and you can carry out network and remote testing as well as measuring.
With the optional UT-M01 (for UTD2025
models) or UT-M05 (for UTD3025 models) Ethernet module, you can
operate the oscilloscope through the LAN interface as follows :
1.
Select “LAN” in the equipment selection option on the real-time control panel.
2.
When “LAN” is selected, the dialog box in Fig 3-5 will pop up.
Fig 3-5
Enter the DSO IP address in this box. The IP addresses set in the software and the communicated oscilloscope
must be the same, otherwise communication between the oscilloscope and the software cannot be established.
Please refer to the oscilloscope user manual for operation instructions. Access sub-menu page 3 by pressing
[UTILITY]
LAN on the oscilloscope control panel for TCP/IP protocol setup. You should set up the IP address,
netmask and default gateway in LAN. In the same network, the IP address of every individual digital storage
oscilloscope is unique and must not conflict with the IP address of any other equipment (in-network IP addresses).
3.
For other operation instructions refer to steps 2, 3, 4, 5, 6 and 7 for “USB interface controls” in this chapter.
Note :
When using the LAN interface, you can operate the oscilloscope by remote control via LAN or the Internet.
Mapping feature of the router must be enabled and the public network address of your company should provided.
