Descriptions
The test function stops after it reaches
a specified pass count number
The test function stops after it
reaches a specified fail count number
Stop condition setting
Use the multipurpose knob to
select stop condition threshold
Return to previous menu
Options
Pass Count
Fail Count
>=
、<=
Functions
Stop Type
Condition
Threshold
Return
11.3 Pass Test
The pass (fail) test is by using a template to detect whether the input signal
satisfies the template requirements.
(1) Function Introduction
Press UTILITY, then press F5 to enter the secondary menu, then press F2
to enter the test menu.
Pass Test Menu (1)
Descriptions
Close Pass Test
Open Pass Test
Set the Pass/Fail interface on the
rear panel : output pulse signal
and produce buzzing when “failure”
et the Pass/Fail interface on the rear
panel : output pulse signal and
produce buzzing when “pass”
Set the source of the pass test
Turn off display information
Turn on display information
Enter Pass Test Menu (2)
Options
Close
Open
Fail
Pass
CH1
、
CH2
Close
Open
Functions
Allow Test
Output
Source
Display Info
½
Pass Test Menu (2)
Descriptions
Disable Pass Test
Enable Pass Test
Enters Stop Settings Menu
Enters Template Settings Menu
Return to Pass Test Menu (1)
Functions
Operation
Stop Setting
Template Setting
2/2
Options
Close
Open
After opening the pass test, you need to set the stop settings and template
settings before you can perform the test function. Otherwise you'll be
prompted "Function is Disabled". The stop setting and template settings
menus are shown as below.
Stop settings menu
UTD2000CEX-II
User Manual
Summary of Contents for UTD2000CEX-II Series
Page 1: ...UTD2000CEX II Series Digital oscilloscope User Manual ...
Page 47: ......
