Service Manual MSO/UPO3000E Serials products
Instruments.uni-trend.com
19
/
27
•
Remove the rear assembly.
Steps:
1.
Use a PH1 Phillips screwdriver to remove one screw, and then take out the signal source daughter board.
2.
To reinstall, reverse the steps.
Remove the front cover
The following procedure describes the removal and replacement of the front cover.
Prerequisites:
•
To prevent electrostatic damage to components while working on the instrument, wear properly grounded anti-
static wrist and feet, and use an anti-static mat in a tested anti-static environment.
•
Remove the front panel knob
•
Remove the rear cover.
•
Remove the rear assembly.
Steps:
1.
Use a PH1 Phillips-tip screwdriver to remove the four screws, and then take the front cover off.
