Service Manual MSO/UPO3000E Serials products
Instruments.uni-trend.com
18
/
27
•
Remove the rear assembly.
Steps:
1.
Use
9/16" open-end wrench to remove the four B
Nuts and washers for NC.
2.
Use a PH1 Phillips-tipped screwdriver to remove the two screws, and then take out the interface board.
3.
To reinstall, reverse the steps.
Remove the signal source daughter board
The following procedure describes the removal and replacement of the signal source daughter board.
Prerequisites:
•
To prevent electrostatic damage to components while working on the instrument, wear properly grounded anti-
static wrists and feet, and use an anti-static mat in a tested anti-static environment.
•
Remove the rear cover.
