![background image](http://html1.mh-extra.com/html/uni-com/250-033/250-033_quick-start-manual_3668406006.webp)
Trouble Shooting Guide and user Hints
Problem
Possible Causes
Suggested Remedy
Chime unit does not sound
when push button is operated
Unit is out of range
Operate the chime unit within
the operation range (80m)
Bell Push transmitter and
Chime unit are not on the
same channel
Follow channel set up
instructions
Batteries need replacing
If the LED doesn
’t illuminate
on the transmitter unit replace
the batteries in the transmitting
unit
If the LED illuminates on the
transmitter unit but does not
illuminate on the Chime unit
replace the batteries in the
chime unit
Door Chime sounds without
push button being pressed
A similar wireless product is
being used on the same
channel
Change the Channel by
follow channel set up
An additional bell push will not
work with existing chime
Units not paired
Follow steps 1 and 2 in adding
an additional Bell Push
Incorrect wiring polarity of
wires in the doorbell
Check wires are fitted as per
instructions
Important
The chime and transmitter unit are sensitive electronic products and the following precautions should be
followed:-
·
Only use in dry conditions
·
Do not expose to direct sunlight
·
If leaving the push button or chime for long periods remove batteries and store safely
·
Do not drop either unit or subject to excessive blows
·
The operating range is up to 80M, however the range of the wireless signal will be reduced if transmitted
through a number of walls or ceilings as well as by metal door or window frames.
Pace Systems Limited
Tel. 0800 0885861
www.pace-systems.co.uk
Warranty
This unit is guaranteed against faulty parts or workmanship for a period of one year from date of purchase. This
Warranty does not cover batteries, damage caused by battery leakage, damage caused by incorrect installation,
or physical damage to the casing.
This guarantee does not affect your statutory rights
Warning
·
Do not mix old and new batteries
·
Do not mix different types of batteries
·
Batteries must be inserted with the correct polarity
·
Exhausted batteries must be removed immediately