Doorbell & Transmitter Fitting Instructions
·
Feed the transmitter wires through the wall or door frame - drill hole if
required. If necessary extend the length of the wires to the transmitter
if they are not long enough to pass through the width of the door/
window frame to which the device is being attached.
·
Fix transmitter unit indoors using the double sided sticky pad
Provided
.
·
Mark and drill holes (if necessary) to mount the Doorbell.
·
Fit the transmitter wires to the Doorbell terminals, attaching the positive
white wire to terminal A and attach the grey wire to terminal C
(ensuring correct polarity) and using the appropriate anti-tamper
screws mount the Doorbell outside.
Positioning and Fixing the Chime
It is recommended that before permanently wall mounting the
chime first test the operation of the unit in the chosen location.
The chime unit can be free standing or wall mounted with the screws
provided
1.
Insert the batteries into the Door Chime Unit (see fitting instructions overleaf)
2.
Position the door chime unit where is can be heard
3.
Site the chime unit in the desired position
4.
Drill the hole as required
5.
Fit the wall plug provided and insert the screw, leaving 5mm between the wall and screw head.
6.
Locate the keyhole slot on the back of the chime unit and slide downwards to fix in place.
Tone set up
The tone selector is a small black button located inside the transmitter unit (shown in
diagram). To remove the cover insert a flat headed screwdriver into the locking slot and gently
twist, see figure 1. The tone is preset at factory to the
‘ding dong’ chime. If you wish to
change the tone , press and release the button until the desired tone is heard. The last one
heard is the one retained within the units memory.
1. Westminster
4. Circus Theme
7. It
’s a small world
2. Ding Dong
5. Banjo on my knee
8 Dog Barking
3. Telephone
6. Twinkle Twinkle
Fixing
Holes
A C
Tone
Selector
CR2032 Battery
3V (supplied)
Operation
Touch the push button once; The door chime unit will sound (and flash if illuminated version)
then stop as soon as the melody ends. For the chime to sound again, the push button must be
touched again.
Note: The doorbell unit features an anti-annoyance feature where by the unit will not
re-activate for a period of 30 to 40 seconds.
Transmitter Unit
To fit or replace battery:
Remove the back of the case by inserting a flat headed screwdriver
into the locking slot and gently twisting, see figure 1. Insert the battery positive side up. Refit
the front of the unit.
Requires 1 x CR2032 3v battery (fitted)
Transmitter Specification
Power
: 1 x 3V Lithium battery (CR2032) Factory fitted
Consumption
: 15mA - on / 0.003mA - Off
Figure 1
Rear View Image of Transmitter and Doorbell
Image of Transmitter with cover removed
Requires 1 x CR2032 3v battery (fitted)
Doorbell Unit
This aluminium vandal proof doorbell has been designed to be positioned
outdoors and works in conjunction with the indoor transmitter and door
chime provided.
