10
EYEXO INSTALL GUIDE
1
sensor bar.
The sensor bar comes with 6 black M6 15mm screws already inserted;
3 screws in the front and 3 screws in the back. Make sure all 6 screws are about
half way screwed into the bar and even in length.
2
Slide the sensor bar with the 6 screws up and over through the bracket
hinges. Make sure the screws are secured in the hook part of the hinges.
Once the sensor is secured in the bracket hinges, tighten the 6 screws to
the bracket.
3.2 Hardware Install - Continued
Step 2: Slide Sensor
Hardware
3
The tilt of the sensor can be adjust with the high and low M6 15 mm screws.
The regular M6 15 mm screws are already screwed into the sensor. You can
change this out with the M6 15 mm High or Low screws to adjust the angle/tilt.
M6 15mm
M6 Low 15mm
M6 High 15mm
