Uneek 4x4 GU-RB-ASM5, Fitting Instructions Manual

Page: 4 / 20

PLEASE READ BEFORE INSTALLATION.
•
This product must be installed exactly as per these instructions using only hardware supplied.
•
Take a few moments to read instructions thoroughly before beginning work.
•
In the event of damage to any bar component please contact Uneek 4x4 in regards to
repair/replacement of components.
•
Do not use this product for any vehicle make or model other than that specified on these
instructions.
•
This product and its fixings must not be modified in any way unless stated in these fitting
instructions.
•
The installation of this product is recommended for trained personnel.
•
These instructions are correct at time of publication. Uneek 4x4 cannot be held responsible for the
impact of any changes subsequently made by the vehicle manufacturer.
•
During installation it is the duty of the installer to check correct operation/clearances of all
components.
•
Supplied tow points are designed as tow points only. Use in a recovery operation will be at
operator’s risk.
•
Installation time:2-3 hours
•
Optional right hand and left hand swing outs are available to carry tyres or jerry cans.
•
This t yre carrier is designed to carry the weight and size of a 35” tyre, carry larger tyres at your own
risk.
•
Always maintain the utmost care when using a hi-lift jack on any vehicle
•
Uneek 4x4 generally covers the LH stub axle with peel off plastic paint which you can peel off when
you purchase the LH swing out.
FASTENER TORQUE SETTINGS:
M6 – 9Nm (4lb ft)
M8 – 22Nm (16lb ft)
M10 – 44Nm (32lb ft)
M12 – 77Nm (57lb ft)
TOOLS REQUIRED: BASIC TOOL KIT WITH SOCKETS, SPANNERS AND HEX KEYS, POWER DRILL, 12MM AND
13MM DRILL BIT
GENERAL PURPOSE GREASE, RUBBER MALLET, Soldering iron with Solder.
EYE & EAR PROTECTION REQUIRED
DRILLING REQUIRED
TWO PERSON LIFT REQUIRED
TORQUE SETTING
CUTTING OR GRINDING REQUIRED