Uneek 4x4 GU-RB-ASM5, Fitting Instructions Manual

Page: 15 / 20

You next need to put the tyre on the carrier
and push the tyre back as far as it can go. The
idea for the bottom of the tyre to rest against
the tyre carrier itself. Mark this position on the
top of the tyre mount as shown with the arrow
to the right. Then move your mark 5mm
further back towards the car to ensure the
tyre is forced hard on to the tyre carrier when
installed. Drill out these holes with 12mm drill
and fit M10x30 bolts with spring washer’s flat
washers and nuts. Torque all bolts.
Wire reverse lights in to vehicle circuit. Wire
stop/tail lamps into circuit. Refer to Narva
lights wiring diagram for which wires operate
what.
Fit tyre on tyre carrier with supplied wheel
nuts and operate tyre carrier to ensure all
motions are good with no binding and adjust if
required.