Uneek 4x4 GU-RB-ASM5, Fitting Instructions Manual

Page: 12 / 20

Wire in your new tail/stop/indicator lights
into the existing wiring circuit.
Best practice is to strip wires back and solder
them to the new wires.
Wire in your new reverse lights into your
reverse light circuit.
Fit M12 x 40 button head cap screws in
through the front of the bar. These bolts are
used hold the rear winch mount if used. If
rear winch mount is not being used these
bolts are simply there to cover the holes.
Fit rear support on LH and RH side with 2 M8
button head cap screws and washers on the
bottom and M8 flange nuts on top for the
outside edge, then use M12 x 40 bolt with
washers and nut through chassis panel as
shown.
Refit your factory mud flaps on to the bumper
and you’re now finished with the bumpe r.