which is the last device in the chain, also has a built-in terminator.
Make sure that no other internal SCSI device in the chain has a termi-
nator.
To install a drive in bay number 2 or 3:
1.
Remove the cover and front panel of the computer.
2.
Remove the two screws that hold the metal shield which
covers bays 2 and 3 in place.
3.
Break the metal shield in two, and screw half of the
shield over the port opening that you do not plan to
use.
4.
Attach the plastic rails that came with your system to
both sides of the drive
.
If you are installing a 5-1/4 inch drive, use the lower screw holes
marked HD on the drive rails. If you are installing a 3-1/2 inch
drive, you need to use an adapter available at your computer
dealer.
5.
Insert the drive, component side down, into the bay
until it clicks into position.
6.
Attach a SCSI connector to the drive.
Attach the side rails and
insert the drive into the bay
