![background image](http://html1.mh-extra.com/html/umax-technologies/powerlook-3000/powerlook-3000_operation-manual_837915025.webp)
19
If you experience unreliable SCSI operation and suspect terminator problems, or
would like a more thorough discussion of SCSI terminators and possible problems
with SCSI terminators, please consult your dealer.
Connecting the Computer and Scanner
Now that the interface card has been installed and all of the settings on the scanner
and card are properly set, you can connect the computer and the scanner. Once this
has been done, the hardware installation will be complete. To connect the scanner
and computer, do the following:
1.
Connect the SCSI cable to the interface card.
2.
If your SCSI configuration requires the use of the terminator, turn on the
terminator switch.
3.
Connect the other end of the SCSI cable to the scanner.
4.
Connect the power cord to the scanner.
5.
Turn on the scanner power.
6.
Turn on your computer power.
Installing the Software for PC Users
Install software in two easy steps, in the following order:
1.
Image Application Software.
2.
MagicScan
MagicScan is the interface used by the application software to control UMAX
scanners. Its advanced controls allow precise adjustments in images even during the
initial scan.
For detailed information on installing the image editing application software, refer to
the Installation section of the Image Editing Application Software User's Guide.
1.
Insert UMAX MagicScan CD into your CD-ROM drive.