11
Cycle abort messages
The Neon Series software has fault modes which will abort the cycle if the programmed
parameters are not met or if any fault occurs.
If the cycle aborts, the reason will be displayed on the screen. An audible warning will
sound to signal a process fail.
To stop the audible warning, press and hold the “enter” button until the warning stops.
If a fault occurs, the Neon Series will display a message on screen and the cycle will
abort:
The cycle may abort for the following reasons:
Level Low
The liquid level is too low
Under Temp
The fluid is below the minimum set temperature
Over Temp
The fluid is above the maximum set temperature
Operator
The operator has aborted the cycle
Sonics Low
The ultrasonic power is too low
Sensor fail
The temperature sensor is faulty
Power fail
There has been a power failure during a cycle
Press and hold the ‘enter’ button to acknowledge the fault and return to operation
mode.
