Ultratec Uniphone 1150, User Manual

Page: 57 / 62

5 5 • S P E C I F I C A T I O N S
Statement of Intended Use
This telephone is intended for connection to the
UK analogue telephone network. The approval of
this modem for connection to the public switched
telephone network is invalidated if the apparatus is
subject to any modification in any material way not
authorized by Ultratec or it is used with or connected
to:
(i) internal software that has not been formally
accepted by Ultratec;
(ii) external control software or apparatus which
causes the operation of the Uniphone 1150 or
associated call set-up equipment to contravene the
requirements of the Standard set out in I–CTR–21
and I–CTR–38.
The Uniphone 1150 has been approved for use of the
following facilities:
following facilities:
• Simple telephone facility
• Timed break recall
• On-hook dialing
• Incoming call indicator
• Speech amplification
• Inductive coupler
• Operation in absence of secondary
proceed indicator
• Recorded speech announcement
• Detection of initial proceed indication
(dial tone)
• Automatic storage of last number dialed
• Tone detection, i.e., ring tone, busy
• Modem
• Automatic answer–data only
• Multi-frequency and loop disconnect dialing
Any other usage will invalidate the approval of
Any other usage will invalidate the approval of
the Uniphone 1150 if, as a result, it then ceases to
conform to the standards against which approval
was gained.
was gained.
You can connect to: :
• Direct exchange lines providing Loop
Disconnect (LD) or Multi-Frequency (MF)
signaling and timed break recall facilities.
• Extension with new plug and socket
arrangement provided with these direct
exchange lines
• Compatible switchboards, including those
which do not provides secondary proceed
indication. If you use the Uniphone 1150
with a compatible switchboard if cannot
be guaranteed that the Uniphone 1150
will operate correctly under all possible
conditions of connection. If you have difficulty,
contact your sales representative for further
information.
• If your switchboard is privately owned, your
Uniphone 1150 can be connected to it by an
authorized maintainer.
You may not connect to: :
• To shared service (party) lines
• To 1+1 carrier systems
• As an extension to a pay phone
The Uniphone 1150 is suitable for connection to
PBX equipment that returns secondary proceed
indication. The Uniphone 1150 is only approved
for compatible PBXs. Please contact your
Uniphone 1150 supplier for a list of PBXs which
are compatible. Because of differenced in the
private telephone system there is no guarantee
that the Uniphone 150 will work correctly in all
circumstances. If you experience any difficulties or
have questions, please contact your supplier.
Approved for connection to telecommunication
systems specified in the instructions for use subject
to the conditions set out in them.