UltraSonic LLC. Model Ultra 6000FLT
4
switch.
Use only UltraSonic LLC approved cleaning agents and be sure you use the proper,
recommended concentrations (typically 10% of approved soap per tank volume for
general purpose cleaning).
•
Check your power supply before connecting unit. The system is designed to operate
on 208v-240V 3Ø 6000FLT Have certified electrician connect power supply. The
unit may require a Buck/Boost Transformer depending on incoming power.
Incoming Power with heaters ON must be above 240 volts will void Machine
Warranty
.
Flip rocker switch
POWER ON/up
button,
Heater Control
&
Ultrasonic
lights will
display green.
Operating temperature is pre-set @ 150°F on the
TEMP CONTROL
. Initial heat-up
time using cold water is approximately two hours. For automatic heating see
Programmer – Heat
When operating temperature of 150°F is reached, set
Ultrasonic Timer
to 15 minutes
and push green
Cycle start
button. This process, known as degassing, will remove air
from the bath, which is required for effective cleaning. During this degassing phase,
some squeaking sounds may occur, this is normal.
Unit is now ready to clean parts, see NORMAL OPERATION procedures.
Fill out WARRANTY REGISTRATION form, page 14 (serial # plate located on
back panel Touch Screen Control Box) and send back to UltraSonic LLC to ensure
activation of your warranty.
