UltraSonic LLC. Model Ultra 6000FLT
3
Do not open up machine, dissemble any part(s), move or remove any components or
electrical devices.
Do not connect the equipment to any other power supply than what is specified.
(220v-240V 3Ø 6000FLT)
The generators contain high voltages and should be maintained in a clean, dry
environment at all times.
Do not move the cleaning system without draining the tank and disconnecting the unit
from the power supply.
Operating temperatures of the solution requires protective clothing and equipment to
protect against the possibility of scalds following accidental spills.
Make sure that the sound levels experienced in your environment are known, and
wear hearing protection if necessary. Ultrasonic energy produced by the system is
measurable by sound meters and OSHA sound restrictions may apply.
Do not leave the ultrasound on or leave parts in the tank longer than necessary. This
can result in erosion of the part surface and/or the bottom of the tank.
Do not allow moisture to build up inside the unit, this can cause electrical shorts and
corrosion of the ultrasonic transducers.
INSTALLATION & INITIAL SETUP
Receiving- Inspect packaging and unit carefully to ensure there has been no damage
in shipping.
If there is damage, contact the carrier immediately to process a
claim
.
Place the unit in a well-ventilated area on a flat level surface.
Lock the casters in place and use the leveling devices located on each side of the unit
if surface is not level.
Both filter elements are already in their designated canisters. To change filter
elements, a 15/16" wrench is required. (Not provided).
Make sure drain valves are closed and then add water and cleaning agent (typically
10% of approved soap per tank volume for general purpose cleaning) to the main
tank. When the main tank is full the water will cascade into the weir tank; continue
adding solution until the level in the overflow tank is 3” above the low water control
