ultraPLAY DC-Seedling, Owner'S Manual & Assembly Instructions

Page: 20 / 46

Issued/Revised:
19
FOOTING DETAIL - SURFACE MOUNT
2
1
3 4
2
5 1
CM
0
INCH 0
10 9 6 11 14 8 15 7 12 13
4 3 6 5
04/15/13
800.458.5872
www.ultraplay.com
1. Attach Upright Posts to Footbuck Ass'ys using M10 x 50mm B.H.C.S. and M10 T-Nut. Be sure to use the bottom two holes in
Footbuck Ass'y. See Detail 009. Peen T-Nut using a hammer to conform around Upright Post.
2. Attach Platform Mounting Bracket to Footer Plate using M10 x 35mm B.H.C.S. and M10 Lock Nut. See Detail 012.
3. Attach Slide Mounting Bracket to Slide Surface Mount Bracket using M10 x 35mm B.H.C.S. and M10 Lock Nut. See Detail 015.
4. Continue assembling the unit. Refer to pages 24 to 44.
5. After unit is assembled using Footbuck Ass'ys and Footer Plates as template, mark hole position on concrete. Remove Footbuck
Ass'y and Footer Plates and drill 3/8" Dia. x 2" deep holes into concrete to receive anchor.
6. Attach Footbuck Ass'ys and Footer Plates to concrete using Concrete Anchor, M10 Flat Washer, and M10 Lock Nut. See Detail 011.
011
FOOTBUCK
ASS'Y
CONCRETE
ANCHOR
(33-11-0706)
M10 FLATWASHER
(33-11-0200)
M10 LOCK NUT
(33-11-0400)
012
FOOTER
PLATE
PLATFORM MOUNTING
BRACKET
M10 x 35mm (1 3/8")
BHCS BOLT
(33-11-0005)
M10 LOCK NUT
(33-11-0400)
015
SLIDE MOUNTING
BRACKET
SLIDE SURFACE
MOUNT BRACKET
M10 LOCK NUT
(33-11-0400)
M10 x 35mm (1 3/8")
BHCS BOLT
(33-11-0005)
009
M10 T-NUT
(33-11-0402)
Peen T-Nut using a hammer
after tightened to conform
around Upright Post.
M10 x 50mm (2")
BHCS BOLT
(33-11-0010)
UPRIGHT
POST
FOOTBUCK
ASS'Y