Installation, Maintenance and Owner's Manual
ULTRAFLEX
page 32
of 143-
POWER ASSISTED STEERING SYSTEM
E
N
G
L
ISH
3.7 Electrical connections
ULTRAFLEX
is not to be held responsible for possible damages or malfunctions deriving from operation not
workmanlike performed.
WARNING
3.7.1 Power cable
The power cable supplied by
ULTRAFLEX
is a high quality salt water and oil resistant cable.
To ensure a correct operation, the power cable cannot be tampered with. It is forbidden to change the cable
length, the fuse or its container and the indications below must be strictly followed. It is only possible to replace
the eyelet connectors supplied as cable ends; in this case, it is necessary to keep the contact protective covers
supplied with the cable or replace them with other ones which can properly cover the electrical contacts.
Find the wiring diagram below:
To make cable passage easier, the fuse holder has been disconnected from the power cable.
In order to connect the fuse holder, after laying the cable, do as follows:
WARNING
Make sure the fuse holder seal has been inserted properly to prevent water penetration.
DANGER
Do not bend the electrical cables near the power unit fairleads: the system explosion-proof safety would no
longer be ensured.
Colour
Use
Red
Positive wire
Black
Ground wire
Remove the transparent cover of the fuse holder
and the fuse.
Put the seal on the conductor until it adheres to the
fuse holder checking that it has been inserted properly.
Insert the faston into the free space of the fuse
holder.
Place the fuse in the fuse holder and put the
proper transparent cover.
NOTICE
Even though the communication cable is made up of quality materials, install it in a dry and sheltered
place, far from saline mist, splashes, etc. Do not install it on external parts.
