Ultraflex K65, Installation Instructions Manual

Page: 59 / 105

KIT K61
-
page 5
of 23
Installation instructions
ULTRAFLEX
ENGL
ISH
1.3 Control cable positioning
1 Select a direct path with a minimum number of bends and without any obstacles.
Avoid too narrow bends (the minimum bend radius is 203 mm (8")).
WARNING
NOTICE
Outboard engine installations require an additional length of about 120 cm (47") of the cables to allow
engine swing.
The cables can be sustained by means of suitable cable hangers (supplied separately) or routed through
segments of conduits (supplied separately too) for long straight runs.
WARNING
2 CONTROL B301:
Remove the rear
cover (7) of the control
by unscrewing the
screws (8) so as to
reach easily the
elements where the
cables are to be fixed.
7
8
8
CONTROL B302:
Split the two boxes
(9), by removing
the screws (8).
8
8
9 9
B 301
B 302
1.3.1 Shift cable connection
1 Place the control
box on a level (the
Ultraflex symbol on
the lever will be
turned upside down).
Remove the cable
clamp (10) from the
plate (11) loosening
the screws (12).
2 Mount the cable
making sure the
cylinder of the cable
(13) is placed inside
the plate hole (14).
10
11
12
4 Fix the cable
clamp (10) to the plate
(11) with the screws
(12).
13
14
3 Remount the
cable clamp (10) on
the plate (11) aligning
the cylinder of the
connector (13) with the
hole of the cable
clamp.
10
13
11
12
11
10
To avoid the control hardening, do not fix the cables near the control outlet (the minimum fixing
distance is 500 mm) and in any case do not use fixing systems that can deform the casing.