Installation and maintenance manual
ULTRAFLEX
page 10
of 63 -
SINGLE LEVER CONTROL B310
ENGL
ISH
3
Insert nut (10) on the
cable end and screw the
terminal (H). Tighten nut
(10). Connect the terminal
to the pivot pin (11) using
snap ring (E).
4
Insert the pivot pin (11) into one of the two holes of the rocker
arm (1) (inner hole for a 67 mm (2,64") and outer hole for a 78
mm (3,07") travel) then attach with the screw (12).
The (black) connector (G), preassembled on the cable, must be
installed in the seat (c) if the terminal of the cable is fastened to
(c1) or in the seat (d) if it is fastened on the other side of the
rocker arm (d1).
11
12
1
c
d
G
15 13
14
3.3.2 Throttle cable connection with push mechanism
1
Remove rubber seals (13), (14) and nut (15)
(on the box side).
2
Insert the cable into the (red) connector (F)
and attach with the split pin (I), using seat (b).
WARNING
Insert and fold the long side of the split pin on the
connector to lock it.
F
I
b
d1
c1
E
11
H
10
RECESS
