SINGLE LEVER CONTROL B310
-
page 11
of 63
Installation and maintenance manual
ULTRAFLEX
ENGL
ISH
3.3.3 Throttle cable connection with pull mechanism
3
Insert nut (10) on
the cable end and
screw the terminal
(H). Tighten nut (10).
Connect the terminal
to the throttle lever
(16) using snap ring
(E).
The
(red)
connector (F),
preassembled on the
cable,
must
be
installed in seat (g).
4
Attach casing
fastener (O) with
screws (L) to
prevent cable
disengagement
from
control
box.
16
H
F
E
g
L
L
O
15
13
14
1
Remove rubber seals (13), (14) and nut (15)
(on the box side).
2
Insert the cable into the (red) connector (F)
and attach with the split pin (I), using seat (a).
WARNING
Insert and fold the long side of the split pin on the
connector to lock it.
F
I
a
3
Insert nut (10) on
the cable end and
screw the terminal
(H). Tighten nut (10).
Connect the terminal
to the throttle lever
(16) using snap ring
(E).
The
(red)
connector (F),
preassembled on
the cable, must be
installed in seat (g).
4
Attach casing
fastener (O) with
screws (L) to
prevent cable
disengagement
from
control
box.
16
H
F
E
g
L
L
O
16
H
E
10
16
H
E
10
RECESS
