SINGLE LEVER CONTROL B310
-
page 9
of 63
Installation and maintenance manual
ULTRAFLEX
ENGL
ISH
3
Turn the lever (6) 180 degrees as shown in the
drawing.
Reinstall spring (5), tube (4), washer (3) and screw (2).
2
3
4
5
6
- Correct control operation depends on precise
adjustment of the shift gear travel.
In no case the travel provided by the control unit
(67mm (2,64") at inner hole and 78 mm (3,07") at
outer hole of rocker arm) should be longer than
the travel allowed by the engine mounted lever.
Failure of the above will result in cable and control
unit damage.
- The sheaths of the cables below the control unit
can be wrapped together or fastened at a minimum
distance of 500 mm (19,7") from the control unit
itself.
WARNING
3.3 C2 - C7 - C8 - MACHZero cable installation
3.3.1 Shift cable connection
1
Remove rubber seals (7), (8) and nut (9)
(on the box side).
2
Insert the cable into the (black) connector (G) and fasten it
with the split pin (I).
WARNING
Insert and fold the long side of the split pin on the connector to lock it.
G
I
9
7
8
WARNING
78
£
78
RECESS
