PUTTING UP THE TRAMPOLINE
There must be a space of at least 7.3 m above the trampoline. With regard to the space at the sides, please ensure that there are
no dangerous objects such as branches, other leisure appliances (e.g. swing, swimming pool), electricity cables, walls, fences,
etc. near the trampoline.
To ensure safe use of the trampoline, be aware of the following when choosing where to put it:
•
Make sure it is placed on a level surface.
•
The area is well lit
•
There are no obstacles on the trampoline
If you do not follow these instructions, you increase the risk of somebody being injured.
ASSEMBLY INSTRUCTIONS
To assemble this trampoline, you need the special spring tension tool included with the trampoline. When it is not in use, this
trampoline can be easily dismantled and stored. Please read the assembly instructions before starting. It is recommended that
this product is assembled by at least two people.
BEFORE THE ASSEMBLY
Refer to the parts descriptions and parts numbers on this page. To make it easier for you, these descriptions and numbers are
used in the assembly steps.
Make sure that you have all listed parts. Refer to this page for how to obtain parts that are missing.
Please use glovesduring the assembly in order to avoid hurting your hands by trapping them.
LIST OF PARTS
PURCHASE NO.
DESCRIPTION
251 cm
1
Trampoline mat with sewn on eyelets
1
2
Frame padding/Protective pad
1
3
Top bar with leg supports
3
4
Top bar
3
5
Base/Foot
3
6
Vertical leg extender
6
7
Galvanized springs
48
8
Spring clamps
1
9
Instructions
1
REMEMBER TO WEAR GLOVES DURING THE ASSEMBLY IN ORDER TO AVOID TRAPPING YOUR HANDS.
AT LEAST TWO PEOPLE ARE REQUIRED TO ASSEMBLE THE TRAMPOLINE.
ASSEMBLY INSTRUCTIONS
STEP 1 - frame assembly
To assemble the frame, a total of 15 tube parts are required. All parts with the same part number are interchangeable and can
be used on both the left or right.
To connect the parts, push the thinner end of a tube into the wider end of another
tube. These connections are called connection points.
Lay out all parts as shown in FIGURE 1.
A. Lay out all frame parts as shown.
In this step, pay attention to the order.
B.You must have the following parts:
1.Top bar with leg supports(#3 , 3 items)
2.Top bar (#4 , 3 items)
3.Base (#5 , 3 items)
FIGURE 1
