4 PIN AUXILIARY SENSOR CONNECTOR*
FULL TRIGGER INPUT
BLACK
GROUND OUTPUT FOR AUXILIARY SENSOR
GREEN
BLUE
PRE-WARN TRIGGER
RED
12VOLT OUTPUT FOR AUXILIARY SENSOR
1- BLUE Pre-Warn Trigger (-) Input
When this wire is grounded by an auxiliary sensor (i.e: Radar Sensor) the system will chirp the SIREN 3 times.
2- GREEN Full Alarm Trigger (-) Input
When this wire is grounded by an auxiliary sensor (i.e: Radar Sensor) the alarm will activate for up to 60 sec.
3- BLACK Sensor Ground Output (-)
This wire provides a ground output for the auxiliary sensor.
4- RED Sensor 12volt Output (+)
This wire provides a 12volt output for the auxiliary sensor.
*ALARM MODELS ONLY
1- WHITE/VIOLET Wire-Ground When Running (-)
Connect this wire to the your bypass modules negative turn on wire. When the remote starter is activated
this wire will switch to ground.
2- BLACK Wire- System Ground (-)
Connect this wire to the ground input on the bypass module.
3- RED Wire- 12volt Output (+) (LOW CURRENT)
Connect this wire the 12volt input on the bypass module.
3 PIN BYPASS CONNECTOR
GROUND OUTPUT
RED
CONSTANT 12 VOLT OUTPUT
BLACK
WHITE/VIOLET
GROUND WHEN RUNNING OUTPUT
The default setting is for idatalink modules. For Fortin bypass modules power-
up the system with the Fortin module connected to the data port to set the default
to Fortin bypass module.
4 PIN DATA BYPASS
*The Thermistor must be connected before power-up to be detected by the system.
The thermistor can be installed in the engine compartment for engine temperature or in
under the dash for interior temperature. The start trigger will activate the remote starter when
grounded.
2 PIN THERMISTOR/ START TRIGGER
SYSTEM PROGRAMMING -
Menu 1
PAGE 14
80 SERIES
INSTALL MANUAL
SYSTEM WIRING DETAILS
SYSTEM PROGRAMMING -
Menu 1
PAGE 15
80 SERIES
INSTALL MANUAL
SHOCK SENSOR PROGRAM
ALARM MODELS ONLY
3 CHIRPS
Press & HOLD Lock + Unlock buttons at the same time
Press & HOLD Lock + Unlock buttons at the same time
Each time the lock button is pressed and released the sensitivity will
INCREASE by 1 level. This is confirmed by a series of park light flashes
& SIREN Chirps
Each time the unlock button is pressed and released the sensitivity will
DECREASE by 1 level. This is confirmed by a series of park light flashes
& SIREN Chirps
Continue to hold the buttons for 3-5 seconds until the SIREN
Chirps 3 times
1 - ENTER SHOCK SENSOR ADJUSTMENT MODE
2 - ADJUSTING THE SHOCK SENSOR
3 - EXITING SENSOR ADJUSTMENT MODE
+
+
(Note: System will Arm or Disarm via silent arming prior to entering adjustment mode)
(1 Flash / Chirp is the least sensitive setting & 10 Flashes / Chirps is the most
sensitive)
(1 Flash / Chirp is the least sensitive setting & 10 Flashes / Chirps is the most
sensitive)
(NOTE: Shock Sensor Adjustment Mode has an auto time out of 8 seconds)
If the system has been triggered (shock sensor, door input..), the siren will sound for
approximately 60 seconds. Press and release the lock or unlock button to silence the siren
(the system will remain armed). Press the unlock button to disarm the system. The siren
and park lights will flash three times to indicate the system had been triggered.
