SYSTEM PROGRAMMING -
Menu 1
PAGE 10
80 SERIES
INSTALL MANUAL
SYSTEM WIRING DETAILS
WHITE
SYSTEM GROUND INPUT
JUMPER SELECTABLE PARK LIGHT OUTPUT (+ OR -)
(+) SIREN/ HORN OUTPUT (-)
STARTER-KILL/ ANTI-GRIND OUTPUT
BLACK
ORANGE
BROWN
BLUE
OUTPUT TO ACTIVATE IGNITION CIRCUIT
WHITE*
SELECTABLE OUTPUT (DEFAULT SECOND IGNITION)
RED
30A HIGH CURRENT 12VOLT INPUT
YELLOW
OUTPUT TO ACTIVATE START CIRCUIT
RED
30A HIGH CURRENT 12VOLT INPUT
GREEN
OUTPUT TO ACTIVATE ACCESSORY/ HEATER CIRCUIT
BLUE
NEGATIVE OUTPUT FOR UNLOCK
12+ OUTPUT FOR DOOR LOCK MODULE
GREEN
NEGATIVE OUTPUT FOR UNLOCK
4 PIN AUXILIARY SENSOR CONNECTOR
SYSTEM PROGRAMMING -
Menu 1
PAGE 11
80 SERIES
INSTALL MANUAL
SYSTEM WIRING DETAILS
PIN-1 YELLOW Starter Output-
This wire will test 0V when the key is off, in the Accessory position and when
the Ignition is in the on position. The starter wire is 12volts during the start/ crank position only.
PIN-2 GREEN Heater/Acc Output-
This wire will test 0V when key is off, 12volts in the ACC and IGN
positions and off during start/ crank position.
PIN-3 RED 12volt Input(30amp)-
This input supplies the 12volt power for the Ignition, Park Lights and
the Selectable output.
PIN-4 RED 12volt Input(30amp)-
This input supplies the 12volt power for the Accessory and Starter
outputs.
PIN-5 WHITE Selectable Output -
2nd Ignition, Accessory or Start output. Programmable.
Note: This output does not switch to default when the system is reset.
PIN-6 BLUE Ignition Output-
This wire will test 0V in the off and Accessory positions the switch to12volts
in the Ignition and Start positions.
PIN-1 BROWN (-) Horn/ (Siren on alarm models) (Programmable)-
Connect to the negative horn wire
on the vehicle for non alarm models. Connect to (+) wire on the siren (Red or Brown) for alarm models.
PIN-2 ORANGE Starter Kill/ Anti-Grind-
This wire can be connected to an additional relay to disable the
start circuit when the lock button is pressed. The output will also stay on when remote started, this will prevent
the starter motor from being re-engaged while the vehicle is running.
PIN-3 WHITE Jumper Selectable Park Light Output (+ or -)-
Connect to the vehicles positive park light
wire or change the jumper and connect to the vehicle negative park light wire. The default position of the jumper
is
Positive Park light Output.
PIN-4 BLACK
System Ground Input-
Connect to chassis ground.
PIN 1- GREEN- Negative Lock Output
Connect to lock wire from the switch on vehicles with a negative type switch. **LOW CURRENT ONLY**
PIN 2- 12volt Output for Door Lock Module
This output will supply 12volts for a plug-in type door lock module. Do not use this input to power-up relays
**LOW CURRENT ONLY**
PIN 3- BLUE- Negative Unlock Output
Connect to lock wire from the switch on vehicles with a negative type switch. **LOW CURRENT ONLY**
6-PIN CONNECTOR
4-PIN CONNECTOR
