Installation Guide
Remote Start
Remote Stop
Idle Mode
Timer / Optional Temp Start
Delay Dome Light - Auto Detection
Ignition Auto Locks
1. Press & release the button.
2. The Park lights will flash and the siren will chirp once.
3. When the vehicle has started, the system will flash the park lights four times and
then remain “On” while the vehicle is running.
4. The vehicle will continue to run for the programmed runtime. (normally 15 minutes).
EXTEND RUNTIME
1. Press & release the
button while the vehicle is running.
2. The system will respond with one park light flash and one siren chirp to confirm
Extended Runtime. The system will reset the run time, (normally 15 minutes).
3 sec.
1. Press and hold the button for three seconds. The remote starter will shut down.
2. The park lights will flash two times and the siren will chirp two times.
Note:
Pressing the brake pedal or opening hood will also stop the vehicle.
1. While the vehicle is running with key, press the button.
2. The park lights will turn on and the siren will chirp once.
3. Turn the ignition key “off” and the vehicle will continue to run.
4. Exit the vehicle and leave it running safely without the keys in the ignition. Lock the
door while the vehicle is left running.
While
running
1.Press & release the
#
button, then press and hold the button for six seconds, until the
parking lights turn “on”.
2. While the parking lights are “on” the start cycle can be selected.
1 hour cycle
or 0C Press LOCK button
1 flash
2 hour cycle
or -5C Press UNLOCK button 2 flashes
3 hour cycle
or -15c Press
button 3 flashes
4 hour cycle
or -25c Press
button 4 flashes
3. System will start vehicle at selected cycle for up to 24 hours.
4.
The temp start must have the temp sensor installed and will only trigger 1 time each 2 hours
if the sensor is not installed the unit will activate the timer mode.
TO CANCEL COLD START MODE
1. Press & release the
#
button, then press and hold the button for four seconds.
2. The park lights will flash and the siren will chirp twice.
1st
2nd-6 sec
Ignition
On/Off
This safety feature will lock the vehicles doors two seconds after the Ignition is turned
to the on position. When the ignition key is turned to the off position the doors will
unlock.
Note
: The system can be programmed for Ignition Lock only. In this setting the door’s
will lock when the key is turned “On” and stay locked when the key is turned “Off”.
#
15
OPERATIONS
If the vehicle is equipped with a factory delay dome light, the system will detect this when arming and
chirp the siren 4 times 15-30 seconds after arming. This conformation will also be activated if the
system is armed with the door open.
