Installation Guide
1
Safety ON
1 Flash
Must press the start button twice to remote start vehicle
2*
Safety OFF
2 Flashes
Press the start button once to remote start vehicle.
Press the Program Switch 8 times
to select setting 8 (This will be confirmed by 8 LED flashes)
Press and hold the Program
Switch until you receive the appropriate # of park light flashes and siren chirps.
Release the Program Switch.
Press the Program momentarily to move to next program step or repeat to change selection.
Setting 8- Safety Start Mode
PROGRAM MODE - TACH SETTINGS
Setting 1- Method 2- Low Idle Tach Learning
Setting 2- Adjust For Over-Crank
Setting 3- Adjust For Under-Crank
Anti Car Jacking Mode
Step 1 - Enter Program Mode
(Ignition ON-OFF-ON-OFF-ON) then press the Program button on the antenna 1 time.
Step 2 - Enter Program Mode 4 -
Press the
#
button on the remote.(Button #4).
Step 3 - Start Vehicle -
Using the ignition key, make sure not to turn the key off at any time or your will exit programming.
Step 4 - Press the Button -
One time (Led will start flashing in single cycles) then press and hold Program (5sec).
Step 5 - Release Program -
Led should come on steady to indicate correct tach signal the park light will flash to confirm.
Step 1 - Enter Program Mode
(Ignition ON-OFF-ON-OFF-ON) then press the Program button on the antenna 1 time.
Step 2 - Enter Program Mode 4 -
Press the
#
button on the remote.
(Button #4).
Step 3 - Press the Program Button -
2 times
(Led will start flashing 2 times).
Step 5 - Release Program - Exit Program Mode and remote start to test.
Step 4 - Press and Hold Program -
For 5 seconds until parking lights flash (each time lights flash tach is reduced 5%).
Step 1 - Enter Program Mode
(Ignition ON-OFF-ON-OFF-ON) then press the Program button on the antenna 1 time.
Step 2 - Enter Program Mode 4 -
Press the
#
on the remote.(Button #4).
Step 3 - Press the Program Button -
3 times
(Led will start flashing 3 times).
Step 5 - Release Program - Exit Program Mode then remote start to test.
Step 4 - Press and Hold Program -
For 5 seconds until parking lights flash (each time lights flash tach is increased 5%).
When activated, the system waits 30 seconds then flashes LED rapidly for 30 seconds, then chirps
siren as a warning for 10 seconds then goes into full alarm .
ACTIVATING CAR JACK MODE-
Programmable - Menu 1, Setting 5.
Activates upon any of the following steps:
- Mode 1 & 2
While ignition is “on” press & release
#
button.
- Mode 1 & 2
Open door while ignition is “on”.
- Mode 2 only
Each time ignition is turned “on”
DEACTIVATING CAR JACK MODE
1. During countdown period - Turn the ignition “On” then press and release the antenna button.
2. After the alarm has activated - Turn the ignition “Off then On” then press and hold the
antenna button for 8 seconds .
ENSURE THAT USER IS FULLY TRAINED ON THIS FEATURE!
ONLY USE THIS FEATURE WHEN SPECIFICALLY REQUESTED. ENSURE THAT USER IS TRAINED
ON THE OPERATION OF THIS FEATURE IF NOT, UNWANTED RESULTS MAY ARISE.
11
This option is used for vehicles that maintain a high or erratic idle after starting and need more that 10
seconds to establish a stable idle.
See page 6 for Auto Tach Learning
