Program mode allows you to adjust the settings and options of your system.
Your system has been intelligently designed by installers with years of experience. The system’s default
settings do not require any program changes in most cases. However, this system does incorporate a highly
advanced programming system that includes 4 menus with numerous options and settings that can be easily
adjusted for custom installations and applications.
User Settings - Page 8
This program menu contains settings that adjust the way the system operates for the user.
Additional Settings - Page 8
This program menu contains settings that control additional user options.
Starter Settings - Page 9
This menu controls features and settings associated with remote car starter applications.
Tach Settings - Page 10
This menu allows the programming of the tach signal and the manual adjustment of that setting.
Programming Overview
Entering Program Mode
Changing the Programmable Settings
1) Make sure ignition is in the off position.
2) Within three seconds turn the key ON - OFF - ON - OFF - ON.
Leave in the “ON” position.
3) Press and release the Program Button on the antenna 1 time.
4) Park lights will come on and the horn (optional) will honk to confirm entering Program Mode.
5) Select Desired Program Menu by the following:
Press Button #1 Lock User Options
Page 8
Press Button #2 Unlock
Additional Options
Page 8
Press Button #3 Start Remote Start Options
Page 9
Press Button #4
Aux Tach Adjustment Menu
Page 10
6) The selected mode will be confirmed by a horn honk (
if connected
)and one park light flash.
7) The Program Menu may be changed at any time by pressing the transmitter buttons as above,
this allows the installer to change a setting from one menu, then quickly jump to another menu
and change another setting without re-entering the Program Mode.
8) Turning off the ignition or 30 seconds of no activity will exit the Program Mode. This will be
confirmed by 1 long horn honk and park light flash.
Note
:
If unit does not enter Program Mode, turn ignition off for 5 seconds and repeat steps 1-4.
**
The first ignition(Blue)
MUST
be connected to the vehicle’s first ignition wire. If it is not connected
1)
Enter
Program Mode
.
2)
Select the desired
Program Menu.
(See pages 8 - 10)
3)
Press & release the
Program Button
the correct number of times to select the desired
Program Setting(
as listed on pages 8 -10
). The park lights will flash and the horn (optional) will
honk to indicate the current setting that is selected.
4)
Hold the Program Button until the parking lights /horn confirm the selected setting. The park
lights will flash and the horn (optional) will honk to indicate the option selected within the setting.
5)
Turn the ignition key “Off” to exit Program Mode.
Note:
This procedure is listed in below each program setting on pages 8 - 10 of this manual.
1) Within 3 seconds turn the key ON-OFF-ON-OFF-ON (Leaving Key ON).
2) Press and release the Program Button.
3) The park lights will turn ON
4) Press the Program Button a second time and hold for 8 seconds until the park lights flash 3
Times and horn (Optional) honks 3 times.
System is now re-set to factory defaults.
SYSTEM RESET
Page 7
Installation Guide
