1250/M Wiring Diagram
Page 3
Pre-Installation
Page 4
Components
Pre Installation Check
Installation Procedures
Wire Connectors
Page 5
6 Pin Connector
14 Pin Connector
3 Pin Red Connector
Jumper Positions
Installation
Page 6
Basic Installation - Quick start
Plug-In The Module
Auto Tach Learn
Programming
Page 7-10
Program Overview
Reset The System To Factory Defaults
Program Menu 1 (User Settings)
Program Menu 2 (Additional Settings)
Program Menu 3 (Starter Settings)
Program Menu 4 (Tach Settings)
Operations
Page 10
Manual Transmission (Reservation Mode)
Additional Operations
Page 11
Transmitter Programming
1st & Second Car Transmitter Programming
Emergency System Service Mode
Battery Replacement
Relay Diagrams
Page 12
If the remote starter has a failed start attempt or if a safety input is activated the Diagnostic Memory will store up to
four shutdowns in memory. This information can then be accessed to determine the source of the shutdown.
To Enter Diagnostic Mode:
Step 1 -
Turn the ignition on wait two seconds then turn off. Press the Program Button and release.
Step 2 -
The system will respond with three park light flashes and the horn will honk (optional) the
same number of times as the events in memory. ( Maximum four events, four honks)
NOTE:
If the horn does not honk, there are no events in memory.
Step 3 -
Press the Program Button once to view the last shut down code. The (optional) Horn will honk once to
confirm code one. (If the horn does not honk, there are no codes in memory).
Step 4 -
The LED’s on the antenna will flash a code corresponding to a shut down trigger. Press the
Program Button again to check the second code. The horn will honk twice to confirm code two.
Step 5 -
To
Clear Diagnostic Memory.
While in Diagnostic Mode press and hold the Program Button for
five seconds. The park lights will flash and the horn(optional) will honk once.
NOTE:
Once diagnostic memory has 4 shutdown events in memory, the system will not record any further
shutdown events until the system memory has been cleared.
Diagnostics
PARK LIGHTS
STATUS LED
DIAGNOSTIC CODE
3 Flashes
Series of 3 Flashes
Door Opened “M” Models
3 Slow Flashes
LED’s On Solid
System Is In Service Mode
4 Slow Flashes
Series of 4 Flashes
Not in Reservation Mode “M” units
5 Flashes
Series of 5 Flashes
Brake Pedal Shutdown
5 Slow Flashes
Series of 5 Flashes
Ignition On During Start Attempt
6 Flashes
Series of 6 Flashes
Hood Pin Grounded
7 Flashes
Series of 7 Flashes
Tach Lock-Out
8 Flashes
Series of 8 Flashes
3 Start Attempts With No Start
Installation Guide Page 2
