Transmitter Programming
Step 1
- Within 3 seconds turn the ignition
ON-OFF-ON-OFF-ON
-
Leaving Key ON
Step 2
-
Press and hold the Program Button
- The park lights will turn ON and the horn(optional) will honk once.*
Continue to hold the Program Button
, the park lights will turn off and the horn will honk 5 times quickly.
Step 3
- While holding the Program Button, press the
LOCK
button on each of the remote’s to be programmed.
If remote’s are being programmed for 2nd Car Operation press the
#
button on each of the
2nd car
remote’s to be programmed.
Note:
The park lights will flash once and the horn will honk once each time a new code is learned.
Note
:
Transmitter programming must done quickly. Do not pause more than one second between each transmitter.
All the transmitters
to be used must be programmed at the same time.
All transmitters not programmed
at this time will be erased from memory for security. The system holds a maximum of 4 transmitter
codes including 2nd car remote codes.
*If the Park Lights do not turn ON, turn ignition OFF, wait 5 seconds and repeat steps 1&2
Carefully remove
the screw from the
back of the remote.
Remove the top case
Then replace the
battery.
Replace top case.
Re-install screw.
Test remote for
proper operation.
Battery Replacement
The transmitter battery should be changed at least once every year to maintain
proper operating range. Replace with quality23A 12volt Alkaline battery.
Ignition 3x
On/Off
On/Off On
Press and
HOLD the
Program
Button
Press the
Lock Button
Press the
Lock Button
Press the
# Button
Press the
# Button
Single Car Operation, Program
up to 4 remote’s
Dual Car, Control 2 Ultra Start
vehicles with the same remote
Page 21
REMOTE VEHICLE STARTER
INSTALLATION MANUAL
