INSTALLATION MANUAL
REMOTE VEHICLE STARTER
Page 2
If the remote starter has a failed start attempt or if a safety input is activated the Diagnostic Memory will store
up to four shutdowns in memory. This information can then be accessed to determine the source of the
shutdown.
To Enter Diagnostic Mode:
Step 1 -
Turn the ignition on wait two seconds then turn off. Press the Program Button and release.
Step 2 -
The system will respond with three park light flashes and the horn will honk (optional) the
same number of times as the events in memory. ( Maximum four events, four honks)
NOTE:
If the horn does not honk, there are no events in memory.
Step 3 -
Press the Program Button once to view the last shut down code. The (optional) Horn will honk once
to confirm code one. (If the horn does not honk, there are no codes in memory).
Step 4 -
The LED’s will flash a code corresponding to a shut down trigger. Press the Program Button again
to check the second code. The horn will honk twice to confirm code two.
Step 5 -
To
Clear Diagnostic Memory.
While in Diagnostic Mode press and hold the Program Button for
five seconds. The park lights will flash and the horn(optional) will honk once.
NOTE:
Once diagnostic memory has 4 shutdown events in memory, the system will not record any
further shutdown events until the system memory has been cleared.
Diagnostics
Diagnostic Memory- With Program LED/Switch.
PARK LIGHTS
STATUS LED
DIAGNOSTIC CODE
3 Slow Flashes
LED’s On Solid
System Is In Service Mode
5 Flashes
Series of 5 Flashes
Hood Pin Opened
5 Slow Flashes
Series of 5 Flashes
Ignition On During Start Attempt
6 Flashes
Series of 6 Flashes
Brake Pedal Shutdown
7 Flashes
Series of 7 Flashes
Tach Lock-Out
8 Flashes
Series of 8 Flashes
3 Start Attempts with no start
- Control module
- Hood pin safety switch
- 6 pin main harness with dual 30amp power inputs
.- 14 pin harness
- 2 Pin keyless entry harness
- Installation guide
- LED/Program Switch
Components
Service Mode is to used when the vehicle is having service work preformed on the vehicle.
Service Mode will disable the remote starter from activating until the service mode is
Deactivated.
ACTIVATING Service Mode
1.While the ignition is “ON” press and hold the Program Button for five seconds. The park lights
will flash five times and the horn (optional)will honk five times to confirm that the system is in
Service Mode.
2. While in Service Mode the remote start functions will be disabled and LED’s will be “ON”
steady. Door locks and trunk release are still operational.
DEACTIVATING Service Mode
1. While the ignition is “ON” press and hold the Program Button for five seconds. The park lights
will flash two times and the horn (optional)will honk two times to confirm that the system has
exited Service Mode.
2. Remote start functions will return to normal operation.
System Service Mode (Valet Mode)
