Page 7
REMOTE VEHICLE STARTER
INSTALLATION MANUAL
1 Type 1
1 Flash
Pulse after start and with lock
2 Type 2
2 Flashes
Pulse after start only
3* Factory Re-arm
3 Flashes
0.75 second pulse with lock and after shutdown
Press the Program Button 3 times
to select setting 3 (This will be confirmed by 3 LED flashes)
Press and hold the Program Button
until you receive the appropriate # of park light flashes and/or horn honks.
Release the Program Button.
Press Program Button momentarily to move to next program step or repeat to
change selection.
Setting 3- Rearm Output- Yellow Wire on 14-Pin
1 30 Min Run Time 1 Flash Remote Starter runs for 30min when activated
2 45 Min Run Time 2 Flashes Remote Starter runs for 45min when activated
3* 15 Min Run Time 3 Flashes Remote Starter runs for 15 min when activated
Press the Program Button 4 times
to select setting 4 (This will be confirmed by 4 LED flashes)
Press and hold the Program Button
until you receive the appropriate # of park light flashes and/or horn honks.
Release the Program Button.
Press Program Button momentarily to move to next program step or repeat to
change selection.
Setting 4- Run Time
1 Type 1
1 Flash
Unlock before start. Lock pulse after start and shutdown
2 Type 2
2 Flashes
Lock pulse only after remote starter shuts off
3* Normal Operation
3 Flashes
No additional re-lock pulses
Press the Program Button 1 time
to select setting 1 (This will be confirmed by 1 LED flash)
Press and hold the Program Button
until you receive the appropriate # of park light flashes and
horn honks.
Release the Program Button .
Press momentarily to move to next program step or repeat to
change selection.
Setting 1- Special Door Lock/ Unlock Operations
Programming Menu
1 Negative Input/ 30seconds 1 Flash Waits a maximum 30 seconds before starting.
2 Timed Delay/ 15 Seconds 2 Flashes
Ignition ON for 15 seconds before engaging remote starter
3* Gas/ Positive Glow Plug 3 Flashes Waits 2 seconds to start if no diesel input is detected
Press the Program Button 2 time
to select setting 2 (This will be confirmed by 2 LED flashes)
Press and hold the Program Button
until you receive the appropriate # of park light flashes and horn honks.
Release the Program Button .
Press momentarily to move to next program step or repeat to change selection.
Setting 2- Gas/ Diesel Mode- Blue Wire on 14-Pin
Turn the ignition key to the on position 3 times then press and release the program button. The park lights
will turn on and the horn(Optional) will honk once. While the park lights are on press and release the program
button until the LED is flashing the same number of times as the program setting that is to be changed.
Press and hold the program switch until the park lights flash the correct number of times as the option to be
programmed.
Continued on next page.....
