Ultra Plus 900HD miCro PVR, User Manual, Page: 40 / 52

40
3. Installation
3.1 Dish Setting
Select the satellite/antenna and LNB settings for se
rvice search. The values that are set in this menu
will be available for selection in other service searc
hing menus.

Satellite : Select the satellite which you want to do
a search for.
-
Press the LEFT/RIGHT ARROW button to select
the satellite.
- If you press the OK button, the entire satellite list
will be displayed.
- Select the desired satellite name to search.
- If the desired satellite name is not listed then select User Defined.

Frequency : Select the satellite frequency which you want to use to check the signal.

LNB Power : Select the LNB power on or off.

LNB Type : Select the LNB type.

LNB Frequency : Select the local oscillator (L.O.). frequency that is specified for the LNB used..
- Use the LEFT/RIGHT ARROW buttons to select the LNB frequency.
- If the required LNB frequency is not listed, then enter the frequency manually using the NUMERIC
buttons.
- When you select Universal LNB type, both 9750 and 10600 are supported at the same time. And
then the LNB 22KHz setting is disabled (as this is used for L.O. switching).

LNB 22KHz : If you use a separate 22KHz tone switch box, enable the 22KHz tone if you are connecting
to the 22KHz side of the switch, and disable it if you are connection to the 0KHz side of the switch.

DiSEqC Switch : If you use DiSEqC 1.0 or DiSEqC 1.1 switch, select one of the DiSEqC inputs.

Service Search : Press the OK button to move to the Search Menu
3.2 Positioner Setting

Satellite : Select the satellite which you want to
search for the Service.
-
Press the
LEFT/RIGHT ARROW
button to select
the satellite.
- If you press the
OK
button, a complete satellite
list will be displayed.
- Select the desired satellite.
- If the desired satellite is not listed then select User
Defined.

Frequency : Select the TP frequency you want to
use to check for a signal.

Positioner : Select the positioner.
-
None : (No Positioner)
- Using DiSEqC 1.2 :
Move :
To move the dish, press LEFT/RIGHT
button.
Fine Move : To move the dish in smaller steps,
press the LEFT/RIGHT ARROW button.
Step : Set to positioner moving steps as 1, 2, 3, 4
Positioner Command : To use various positioner
commands, press the OK button. Then, available positioner commands will appear.