16
GB/IE/NI/CY/MT
compressor
1
to the inflatable
item which you want to inflate. To
do so, please proceed as follows.
Use the “M” menu button
5
to select the desired unit of
pressure. The units available are
bar (“bar”), kilopascal (“KPa”),
kilogram per square centime-
tre (“KG/CM²“) and pound per
square inch (“PSI”) (see Fig. E).
Use the “+” button
3
and the
“-” button
4
to select the desired
pressure. To speed up the selec-
tion, you can keep the respective
button pressed down. Pressure
settings between 0.3 bar and
3.5 bar are possible in 0.05 bar
steps (see Fig. E).
Note:
While preselecting the pres-
sure, the digital pressure gauge will
flash with the pressure display
6
.
If a button is not pressed for at least
10 seconds, the display will display
the ACTUAL value of the pressure.
The pressure which has been set
remains stored.
Switch on the integrated com-
pressor by switching the On/Off
switch for the compressor
2
to
“On” (position I).
The compressor will start and
pump up the inflatable item.
You can switch off the compressor
at any time by switching the On/
Off switch for the compressor
2
to “Off” (position 0).
Otherwise, the compressor will
switch off automatically once the
inflatable item has reached the
preset pressure.
In this case, once the preset
pressure has been reached and
the compressor automatically
switches off, switch the On/Off
switch for the compressor
2
off
(position 0).
Disconnect the inflatable item
from the compressed air hose
17
as described in the previous
section.
At the end of work, screw the
compressed air hose
17
back off
the hose connection
15
of the
power bank with compressor
1
.
Attention:
The hose connection
15
of the power bank with compressor
1
heats up during operation.
Make sure that you do not come into
contact with the hose connection
15
during operation to avoid suffering
burns. At the end of work, wait
for at least 10 minutes before you
unscrew the compressed air hose
17
back off the hose connection
15
of
the power bank with compressor
1
.
Note:
After switching on the power
bank with compressor
1
with the
power bank switch
9
, the device
switches off automatically after
approximately 20 seconds if the
compressor is not started or if no
consumables are connected.
Summary of Contents for UPK 10 E2
