GB/IE 5
Car seat cover set
Introduction
We congratulate you on your purchase. You have chosen a high
quality product. The instructions for use are to be considered as
part of this product. Before using the product, please familiarise
yourself with all the safety information and instructions for use. Only use the
product as instructed and only for the stated areas of use. If you pass the product
on to anyone else, please ensure that you also pass on all the documentation
with it.
Intended use
Set of car seat covers for the driver‘s seat, passenger‘s seat and the back
seats of cars (according to the enclosed type list).
Scope of delivery
2 x covers for front seats (in 1 or
2 - 5 x covers for headrests
2 parts according to design)
(according to design)
1 x cover for rear backrest (in 1
1 x cover for back seat (not sepa
to 5 parts according to design)
rable)
Metal hooks (located in the
List of types
headrest covers)
Safety instructions
Correct installation res. fastening of the seat covers to the vehicle is essential
to guarantee the safety of the user. Please pay attention to the following
information when installing the seat covers:
DANGER OF SUFFOCATION!
Keep
the packaging out of reach of small children.
Installation is permissible only in cars that are indicated in the list of types
on the packaging or in the enclosed, detailed list of types.
Correct assignment of the seat (driver and front passenger seat). The
covers are assigned by the marking „airbag“ attached to the seat cover.
This marking must be attached to the outer side of the backrest
(see fig. 1.0).
Headrest inserts, adjustment levers / wheels for release of backrests or
armrests may not be covered with the seat cover. Allowances must be
made for appropriate inserts. Please observe the instructions given in
section “Installation”.
Displaced seat covers must be repositioned. If this is no longer possible
due to a advanced state of wear and tear, the cover must be removed or
replaced.
Manipulation of the opening of the seat covers is not permissible
(no covering, sewing up or repairs by yourself).
This protective cover has been tested by TÜV Rhineland Group.
CAUTION!
If the seat covers are installed incorrectly, the proper extension
and inflation of the seat air bag cannot be guaranteed in the case of a
collision.
Installation
You need a pair of pointed scissors.
Installation of seat covers
Important:
Please read the information below before installing the seat covers!
Fig. 1:
Remove headrests (in some car models the headrests must
be dismantled in a garage).
Fig. 2:
Cover the backrest by pulling the cover downwards.
Fig. 3:
Pay attention to the correct assignment of the side airbag
label (right / left seat)! The side airbag label must be located
at the outside (door side) of the respective seat.
Fig. 4:
Pull the strap through between the seat and the backrest.
Fig. 5:
Then close the fastener.
Fig. 6:
Cover the seat from the front to the back.
Fig. 7:
Fasten the metal hooks to the rubber loops.
Fig. 8+9:
Pull the rear rubber loops between the seat and backrest
(as you did with the strap of the backrest cover). Fasten the
metal hooks under the seat according to the car model
(e.g. to the existing metal rods - ATTENTION Do not fasten
to airbag cables!)
Fig. 10:
Or fasten all rubber loops together.
ATTENTION!
Openings for backrest releases, adjustment levers, side levers etc. (as described
under fig. 11–21) must be cut out.
Fig. 1.0
WARNING!
