UNPACKING & ASSEMBLY
Unpacking your treadmill where will be using it. Being careful not to damage. Place your treadmill on a
level flat surface. It is recommended that you place a protective covering on your floor.
STEP1- Attach the console masts to the base frame
A
. Insert the left console mast (without a wire attached inside) into the base frame. Secure the left
console mast with 3pcs M8X15mm bolts using allen wrench.
B.
Put the electronic wire inside and through the right console mast using the wire attached inside the
right console mast.
C.
Insert the right console mast into the base frame, secure the right console mast with 3pcs
M8X15mm bolts using allen wrench.
STEP2- Attach the console to the console mast
A
.Please unloose the tie of the wires of the handle button.
B.
Respectively connect the console wire and ground from the console and right console mast.
C.
Put the connector and wire inside the right console mast.
D.
Algin the console with the holes in the console mast, the console with 2pcs M8X50mm bolts (see
B&B' on assembly drawing) using allen wrench.
Note:
Do not securely tighten the screws until
STEP 3D
.
STEP 3- Attach the side handlebar to the console mast
A.
Respectively connect the wires of the handle button from the console and side handlebars.
B.
Insert one end of the side handlebars into the console, algin the side handlebar with the holes in the
console and the console masts, the side handlebar with 2pcs M8X50mm bolts (see A, A' on assembly
drawing) using allen wrench.
C.
Align the side handlebar
with the hole in the console
mast, secure the
handlebar with 2pcs
M8X95mm bolts using
allen wrench.
D.
Tighten all bolts used
during
STEP 2D
and
3B.
E.
Insert 4pcs of plastic
end caps into the holes on
console.
Summary of Contents for Active8
Page 6: ...UNPACKING ASSEMBLY PARTS Hardware kit...
Page 15: ...EXPLODED DRAWING...