Step 6 Remove the drilled pocket hole joint from
the jig, see diagram below.
The pocket hole jig can be turned into a
portable pocket hole guide by attaching the
optional portable base plate (F), see instruction
below.
1. Remove the guide block and thickness guides
from the base plate by removing the four Hex
screws.
2. Attach the portable base plate (F) to the
thickness guides with the Hex screws.
DO NOT OVERTIGHTEN! (See diagrams above)
Optional Accessories
Portable Base Option
D
E
E
I
E
F
G
H
E
F
Locate the dust extractor assembly and the two
Hex screws (D). Line up the pre-drilled holes with
the threaded holes to the front of the guide block
and secure with the two Hex screws.
Fitting the dust extractor
Screw Chart
D
1. Line-up the joints, attach the long torx 20 drive
bit (B) into your cordless drill.
2. Set the drill to a LOW
torque
setting, so as not to
overdrive the screw.
3. Choose the correct screw length for your
application.
4. Place washer head self cutting screws down into
the pocket holes and screw the two joints together.
(See diagram below)
Assembly Suggestions
When assembling we recommend the following:
• A clear work bench
• A workstop (a length of straight timber
clamped to either end will suffice)
B
Washer head self
cutting screw
Pocket hole joint
Pocket hole joint
Pocket hole joint
Thickness guide
Portable
base plate
D
x1
UJK Extractor Outlet for
Pocket Hole Jig with two
Hex screws
Code
503801
E
x1
UJK Technology Face
Clamp
Code
503727
F
x1
UJK Technology Portable
Base Plate
Code
503802
G
x1
UJK Technology Short Torx
T20 Pozidrive bit
Code
503456
H
x1
UJK Technology Alignment
Clamp with quick release
Code
502710
I
x1
UJK Technology M35
Cobalt Quick Change
Shank production bit
Code
507244
UJK Technology is a registered trade mark of
Axminster Tools & Machinery Ltd
ujktechnology.co.uk
Timber Thickness
Screw
13-18mm
25mm
19-25mm
30mm
26-30mm
35mm
31-37mm
50mm
38+mm
60mm
Select the correct type of screw.
Fine thread for hard wood, Course thread for
soft wood.
