UINICS SP-490 Series, Operation Manual

Page: 14 / 32

- 11 -
９．Initial setting values and initialization
If the specifications desired by the user are requested prior to shipment, the meter will be set
these settings. Otherwise, the regular factory settings are shown below.
１．Value setting of each Mode
Table 1
Mode No. Initial setting Notes
ＣＤ Ｅ Ｆ Ｇ Ｈ Ｅ Ｆ Ｇ Ｈ
００ ０ ２ ０ ０
０１ １ ０ ０ ０
０２ ３ ０ ０ ２
０３ １ ０ ０ ０
０４ ３ ０ ２ －
０５ ０ ０ ２. ０
０６ ０ ０ ０ ０
０７ ０ １ ０ ０
０８ ０ １ ０ ０
０９ ０ ０ ０ ０
１０ ０ ０ ０ ０
２．Preset value setting of each alarm output
Table 2
Alarm No. Initial setting Notes
ＡＢＣＤ Ｅ Ｆ Ｇ Ｈ Ｅ Ｆ Ｇ Ｈ
ＯＵＴ１ ９ ９ ９ ９
ＯＵＴ２ ９ ９ ９ ９
ＯＵＴ３ ９ ９ ９ ９
ＯＵＴ４ ９ ９ ９ ９
３．Mode protect
Table 3
Initial setting Note
off
Initialization：Turn power on with Reset key being pressed to initialize the settings.
After the initialization, the set values will be as shown in Table 1-3.
※ In case the computer froze when unusual functioning occurred with the normal
operation, initialize according to the above procedure and set the desired value again.
Note：Since an initialization changes all existing setting values to the initial setting values,
be sure to record all the setting values before an initialization.