MD40
PRODUCT INSTRUCTION MANUAL
MD40
Page 27 of 55
Author: N.Carapiet | Revision: 1.1
1.
Push Drive Thimble over the Flange Assembly (take care when re-coupling the magnets
–
the magnetic coupling may cause a sudden movement)
2.
Replace Bearing Cap and M3 grub screws
3.
Replace the actuator drive housing. The housing must be correctly orientated using the
alignment screw on the flange and the cut out in the actuator housing bore without the
additional cut-out.
4.
Replace Thimble Cover and tighten 2 x Actuator Housing Screws
Refitting the Motor Assembly
1.
Align the drive pin with the slot in the Drive thimble
2.
Install the motor assembly. Orientation is defined by the Alignment Screw
Motor Assembly
2 x M4 Cap Head Screws
