User Manual |
13
EN
C- INSTALLATION OF YOUR PRODUCT
Selecting the place of installation
The operating environment of the product is very important for the smooth operation of your product. While
selecting the operating environment,
Do not place your product exposed to outdoor environment (on the street, avenue, etc.).
Be careful for not obstructing lower shutter of the product with materials such as cardboard, box etc. for a
proper cooling (Picture 3).
Place the product at least one (1) meter away from heat resources (stove, radiator, electric heater etc.) (Picture
4).
Do not place it opposite to the air conditioner chutes, under fans and direct door and window openings
(Picture 5).
Do not expose to direct sunlight. Operation ratio will increase if sunlight comes to your product’s glass. That
means an increase in the energy consumption.
Air intake and outlet must absolutely be fluent and free for proper operation of the compressor section of
your product.
While approaching your product to the wall, be careful that there is a gap of 150 mm (15 cm) between the wall
and back of your device.
WARNING!
In very humid environments, ensure that floor and wall of the place where your product is located, is not
affected by water; against discharge water overflow danger.
In installations performed by Authorized Service, Authorized Service shall inform the consumer on the
suitable place for installation and make suggestion, but the consumer shall give the final decision on
where the installation will be made. This above mentioned process shall also be stated on the relevant
installation form by Authorized Service. In case of any loss arising from the place of installation of the
product according to the final decision given by the consumer, all responsibility related to such loss shall
belong to the consumer.
Your product gives the best cooling performance according to the climate condition under the conditions
given below. Therefore, be careful that the temperature of the environment where your product will operate
is at these levels.
PICTURE 3
