UGO BASILE 47650, Instruction Manual

Page: 28 / 39

Page 22
47650 Instruction Manual (Rev. 2.1)
When the diagnostic sequence is completed, a
report can be saved to USB
5.7.4 Reset HD
This button resets the HD, which contains ALL THE EXPERIMENTAL DATA.
A message box will ask to confirm the action.
ATTENTION :
After confirming the procedure, it will be impossible to recover the data.
5.8 Signal Output
For some sophisticated application, and interface with other systems, it might be useful to
obtain outputs for lane status, rotation and speed.
The 15-pin D-SUB connector (see picture
and paragraph 3.8) provides different
output trigger, in the form of TTL signals.
All pins, except pin 8, are TTL digital
signals. Pin 8 is an analog output which
provides the rotation speed.
Pins 14 and 15 are ground.
5.8.1 Pin-Out
Pin No. DESCRIPTION LEVEL LOW LEVEL HIGH
Pin 1 PLATE 1 STATUS PLATE UP PLATE DOWN
Pin 2 PLATE 2 STATUS PLATE UP PLATE DOWN
Pin 3 PLATE 3 STATUS PLATE UP PLATE DOWN
Pin 4 PLATE 4 STATUS PLATE UP PLATE DOWN
Pin 5 PLATE 5 STATUS PLATE UP PLATE DOWN
Pin 6 ROTATION SENSE REVERSE NORMAL
Pin 7 EXPERIMENT STATUS NOT RUNNING RUNNING
Pin 8 (*) ANALOG SPEED OUT 3 RPM = 0.5V 80 RPM = 8V
Pins 9 – 13 NOT USED