UGCS SkyHub, User Manual, Page: 52 / 123

9. Restart the drone by a power cycle. The UgCS SkyHub device should be properly
connected to the flight controller.
10. Wait for the UgCS SkyHub firmware loads and starts. The DJI mobile application may
request you about additional permissions for the Onboard SDK. Confirm all of them
allowing the UgCS SkyHub to access the DJI autopilot.
Now the flight controller is ready to be connected via Onboard SDK. Default DJI App ID and
Key are used.
Important: The DJI flight controller may not activate from the first attempt. If there is no
connection with flight controller after full system setup, try to repeat steps from 8 to 10
several times with the drone power cycling.
Option 2: Using User’s Credentials
Otherwise, one may use his credentials while the DJI flight controller activating. In this case,
follow the steps described below.
1. Create an account on https://developer.dji.com/ then enter to Apps tab in the
developer area.
2. Choose ONBOARD SDK and press CREATE APP.
Figure 12.8 — DJI Developer area
3. Enter corresponding information and press CREATE.
Setup Interface to DJI Autopilot
UgCS SkyHub User Manual
Copyright © 2019—2021, SPH Engineering 52 Revision 5 • November 2021